Snoop的使用舉例如下:
1. 先設置過濾列表,使得防火墻只對需要的數據包進行分析. 即snoop filter命令:
ns208-> snoop filter ?
delete delete snoop filter
ethernet snoop specified ethernet
id snoop filter id
ip snoop ip packet
off turn off snoop filter
on turn on snoop filter
tcp snoop tcp packet
udp snoop udp packet
ns208-> snoop filter ip ?
<return>
direction snoop direction
dst-ip snoop filter dst ip
dst-port snoop filter dst port
interface interface name
ip-proto snoop filter ip proto
port src or dst port
src-ip snoop filter src ip
src-port snoop filter src port
<IPv4 Address> IPv4 Address
offset ip offset
ns208-> snoop info
Snoop: OFF
Filters Defined: 2, Active Filters 2
Detail: OFF, Detail Display length: 96
Snoop filter based on:
id 1(on): IP dir(I)
id 2(on): IP dst-ip 172.27.68.1 dir(B)
2. 開啟snoop 進行抓包
ns208-> snoop
Start Snoop, type ESC or 'snoop off' to stop, continue? [y]/n y
3. 發送測試數據包或讓小部分流量穿越防火墻
4. 停止snoop
ns208-> snoop off
5. 檢查防火墻對所轉發的符合過濾條件的數據包的分析結果(非采用上面的filter,而是采用另外的filter):
ns208-> get db stream
1.The packet comes into the Netscreen from the Trusted side client.
55864.0: 0(i):005004bb815f->0010db00ab30/0800
10.0.0.36->10.10.10.14/1, tlen=60
vhl=45, id=31489, frag=0000, ttl=32
2.The packet then leaves the Netscreen, on it’s way to the destination host.
55864.0: 1(o):0010db00ab31->00104bf3d073/0800
10.10.10.10->10.10.10.14/1, tlen=60
vhl=45, id=31489, frag=0000, ttl=31
3.The packet then returns to the Netscreen from the host.
55864.0: 1(i):00104bf3d073->0010db00ab31/0800
10.10.10.14->10.10.10.10/1, tlen=60
vhl=45, id=12289, frag=0000, ttl=128
4. Finally, the packet is returned to the client on the trusted side.
55864.0: 0(o):0010db00ab30->005004bb815f/0800
10.10.10.14->10.0.0.36/1, tlen=60
vhl=45, id=12289, frag=0000, ttl=127
5. 清除防火墻緩存的debug結果:
ns208-> clear db
6. 清除防火墻的snoop過濾設置
ns208-> snoop filter delete
All filters removed