1）

8044 "pdflush" c68be034 { } | __ide_do_rw_disk | ide_do_rw_disk | start_request | ide_do_request | do_ide_request | __generic_unplug_device | __elv_add_request | __make_request | generic_make_request | submit_bio | mpage_bio_submit | __mpage_writepage | mpage_writepages | ext2_writepages | do_writepages | __sync_single_inode | __writeback_single_inode | generic_sync_sb_inodes | sync_sb_inodes | writeback_inodes | wb_kupdate | __pdflush | pdflush | kthread | kernel_thread_helper

2）

1288 "kjournald" de850034 { } | __ide_do_rw_disk | ide_do_rw_disk | start_request | ide_do_request | do_ide_request | __generic_unplug_device | generic_unplug_device | blk_backing_dev_unplug | sync_buffer | __wait_on_bit | out_of_line_wait_on_bit | __wait_on_buffer | sync_dirty_buffer | journal_write_commit_record | journal_commit_transaction | kjournald | kernel_thread_helper

3）

4409 "syslog-ng" dccf6034 { } | __ide_do_rw_disk | ide_do_rw_disk | start_request | ide_do_request | do_ide_request | __generic_unplug_device | cfq_start_queueing | cfq_crq_enqueued | cfq_enqueue | cfq_insert_request | __elv_add_request | __make_request | generic_make_request | submit_bio | submit_bh | __block_write_full_page | block_write_full_page | ext3_ordered_writepage | mpage_writepages | do_writepages | __filemap_fdatawrite_range | filemap_fdatawrite | do_fsync | sys_fsync | sysenter_past_esp

4）

448 "kblockd/0" dfe20034 { } | __ide_do_rw_disk | ide_do_rw_disk | start_request | ide_do_request | do_ide_request | cfq_kick_queue | worker_thread | kthread | kernel_thread_helper

希望對分析DISK IO的關系有一點幫助。

CODE：//in drivers/ide/ide-disk.c /* * __ide_do_rw_disk（） issues READ and WRITE commands to a disk，* using LBA if supported， or CHS otherwise， to address sectors. */

ide_startstop_t __ide_do_rw_disk（ide_drive_t *drive， struct request *rq， sector_t block）

{ ide_hwif_t *hwif = HWIF（drive）；unsigned int dma = drive->using_dma；u8 lba48 = （drive->addressing == 1） ？ 1 ： 0；task_ioreg_t command = WIN_NOP；ata_nsector_t nsectors；

nsectors.all = （u16） rq->nr_sectors；

if （hwif->no_lba48_dma && lba48 && dma） { if （block + rq->nr_sectors > 1ULL << 28）

dma = 0；else lba48 = 0；}……

}